The use of superscripts and subscripts is very common in mathematical expressions involving exponents, indexes, and in some special operators. This article explains how to write superscripts and subscripts in simple expressions, integrals, summations, etcetera.
Contents 
Definite integrals are some of the most common mathematical expressions, let's see an example:
In LaTeX, subscripts and superscripts are written using the symbols ^
and _
, in this case the x and y exponents where written using these codes. The codes can also be used in some types of mathematical symbols, in the integral included in the example the _
is used to set the lower bound and the ^
for the upper bound. The command \limits
changes the way the limits are displayed in the integral, if not present the limits would be next to the integral symbol instead of being on top and bottom. (see the reference guide)
The symbols _
and ^
can also be combined in the same expression, for example:
If the expression contains long superscripts or subscripts, these need to be collected in braces, as LaTeX normally applies the mathematical commands ^
and _
only to the following character:
Subscripts and superscripts can be nested and combined in various ways. When nesting subscripts/superscripts, however, remember that each command must refer to a single element; this can be a single letter or number, as in the examples above, or a more complex mathematical expression collected in braces or brackets. For example:
Some mathematical operators may require subscripts and superscripts. The most frequent cases are those of the integral \int
(check the introduction) and the summation (\sum
) operators, whose bounds are typeset precisely with subscripts and superscripts.
For other frequently used operators that require subscripts/superscripts check the reference guide.
Additional examples and operators
LaTeX markup  Renders as 

a_{n_i}


\int_{i=1}^n


\sum_{i=1}^{\infty}


\prod_{i=1}^n


\cup_{i=1}^n


\cap_{i=1}^n


\oint_{i=1}^n


\coprod_{i=1}^n

There are also a bigcup
and bigcap
commands similar to cup and cap but larger for larger expressions.
For more information see